I used a regular long-tail cast-on and began the K1, P1 ribbing from the start in 2 rounds of green and 28 rounds of black.

After the cuff, I placed my increases a by following a K3, make 1 pattern around, counting the increase round as the first row of the chart.

I’m not sure if it’s due to the small hands of the person I am making them for or if it is because I am making finger holes, but the fourth row of Creeper faces makes it too long, so following the third row of faces and finishing the pixels on the opposing side evenly, I knit 2 plain rows of black before sectioning off the fingers. They have been separated as follows:

Index finger - 10 sts on one needle (20 total)
Middle finger - 12 sts on one needle (24 total)
Ring finger - 10 sts on one needle (20 total)
Pinky - 8 sts on one needle (16 total)

Pinky - CO 2 sts on the inside of the finger; K 6 rounds in black & 2 K1, P1 in green for 2 rounds, bind off.

Ring finger - Pick up the stitches cast on the previous finger & cast on 2 new stitches on the inside of the finger; K 8 rounds in black, K1, P1 for 2 rounds in green, BO.