Gros Morne Cloak by Raven Knits Design

Gros Morne Cloak

Knitting
December 2018
Worsted (9 wpi) ?
20 stitches and 26 rows = 4 inches
in stockinette unblocked
US 7 - 4.5 mm
US 6 - 4.0 mm
850 - 950 yards (777 - 869 m)
20” deep by 60” bottom edge circumference after blocking
English
This pattern is available for C$9.30 CAD buy it now

Soaring fjords and moody mountains tower above a diverse panorama of beaches and bogs, forests and barren cliffs. Shaped by colliding continents and grinding glaciers, Gros Morne’s ancient landscape is a UNESCO World Heritage Site. Wander coastal pathways and beachcomb among sea stacks. Cruise the dramatic, sheer-walled gorge of Western Brook Pond. Spot moose and caribou. Hike to alpine highlands where Arctic hare and ptarmigan thrive on tundra, and explore the colourful culture of nearby seaside communities.

The Gros Morne cloak is worked seamlessly from the collar down, using shaping at the shoulder that is similar to a Faroese shawl but extended so that the front edges meet. The half hitch cables of the front and back panels and the running cables along the bottom border add interest and a slightly Nordic feel; a nod to the Viking ruins on the other side of island from Gros Morne itself. The cloak is easily held closed using a shawl pin at the throat, or permanent fastenings may be sewn onto the collar. If fastenings are sewn on, I recommend also sewing in a fabric backing to prevent the collar from stretching over time.

Materials Needed:

  • @875 yards worsted/light aran weight yarn
  • 4.5mm (US 7) circular needle or size needed for gauge
  • 4mm (US 6) circular needle or one size smaller than size needed for gauge
  • 4 stitch markers to mark edges of the cable panels

Optional Materials:

  • an additional 24 stitch markers to mark repeats of bottom cable
  • sewn on cloak fastening(s)
  • ribbon facing to sew around collar and behind cloak fastening(s)
  • cable needle

Gauge: 20 sts x 26 rows = 10cm (4 inches) in stockinette on larger needles unblocked

Size: 20” deep by 60” bottom edge circumference after blocking