Phoenix Feather by Natalia Sha

Phoenix Feather

Knitting
Fingering (14 wpi) ?
US 1½ - 2.5 mm
2.5 mm
383 - 547 yards (350 - 500 m)
width – approx. 18 cm [7 in], length – adjustable
English German Russian


This narrow rectangular scarf, featuring a lace pattern at both ends, consists of two identical halves which are grafted in Kitchener stitch and is worked from the ends towards the center.
While the length of this scarf is adjustable to personal preferences; its width can’t be altered.

The 13 page pattern contains charts, step-by-step photos for the cast-on method and detailed instructions. Basic crocheting and grafting skills are required for cast-on and joining.

Difficulty level: rather advanced, but not too much

Yarn recommended: YarnStories wool
Total yarn amount needed: 350 – 500 meters (383 – 547 yds)
(or more – depending on desired length)

Needles: US 1½ – 2.5 mm

Additionally:
• crochet hook 2.5 mm (UC B/C) for provisional cast-on
• tapestry needle for grafting


Dieser schmale lange Schal mit einem Lacemuster an beiden Enden besteht aus zwei identischen Hälften, die von den Enden zur Mitte hin gearbeitet und anschließend im Maschenstich zusammengefügt werden.
Die Länge kann je nach Bedarf angepaßt werden, während die Breite wegen des Musters unveränderlich ist.

Die 13-seitige Anleitung enthält Strickschriften, ausführliche Anweisungen und Fortschrittsfotos für den Maschenanschlag.

Gesamtgarnbedarf ca. 350 – 500 m (oder mehr – abhängig von der gewünschten Länge)

• Stricknadeln: Gerade bzw. Rundstricknadel 2,5 mm
• Häkelnadel 2,5 mm für den Maschenanschlag
• Wollnadel

Fertige Größe:
Breite – ca. 18 cm, Länge – anpaßbar (abgebildeter Schal aus 150 g YarnStories wool, 350 m / 100 g: 217 cm lang)