Bingpot Beanie by Jacki Badger

Bingpot Beanie

October 2020
DK (11 wpi) ?
24 stitches and 32 rows = 4 inches
in Measured over coloured panel, knit in the round
US 4 - 3.5 mm
US 6 - 4.0 mm
122 - 245 yards (112 - 224 m)
0-6m, 6-12m, 1-3y, 4-10y, teen/small adult, large adult
Flag of English English
This pattern is available for £4.00 GBP buy it now

Kit out the entire family in a slouchy, comfy, and colourful hat that’s way easier to knit than it looks. The Bingpot Beanie’s coloured panel may look swish, but it only uses one colour per round – making it no harder than a basic stripe.

It uses DK weight yarn - so it knits up fast – and with each coloured stripe being just two rounds wide, it’s a brilliant way to use up scrap yarn. Go for the entire rainbow or keep it a bit calmer with a classic two-tone contrast. The Bingpot beanie works with whatever’s in your stash.

But it’s not just fun to knit. It’s also super cosy and comfy to wear. Bingpot comes in 6 sizes, from 0-6m up to large adult. And you can pick from two looks - a slightly slouchy version, or a super slouchy, depending on the look you’re after.

The photos show the large adult hat in the super slouchy fit, and the child (4-10ys) hat in the slightly slouchy fit.

Its stretchy ribbed brim and roomy fit make it super-comfy for even the fussiest of toddlers. Believe me. My family have extensively tested it.

Key information
The Bingpot Beanie is knitted in the round using DK yarn. It can be worked on either DPNs or circular needles, depending on what you prefer (see key information for some notes on using circular needles with this pattern).

The coloured panel uses mosaic knitting, which is a fancy name for some very simple colourwork. It uses only one colour per row, so is no more complex than knitting a basic stripe but gives a fantastic finish.

The pattern is sized for 6 sizes ranging from 0-6m old baby to large adult. Instructions are written as “0-6m, (6-12m, toddler, child) teen/small adult, large adult”, so make sure you’re looking at the right numbers for the size you’re knitting. All sizes use the same simple four-stitch repeat for the colourwork section, which is both written out and charted.

Suggested yarn: This pattern will work with most DK weight yarns. The samples use Eden Cottage Yarns Milburn DK (112m/122yds per 50g).
See the table below for yarn requirements.
For hints and tips on yarn substitution, have a look at my blog.

Suggested needles (and notions): 3.5mm (US 4) and 4mm (US 6) needles suitable for knitting in the round – or size needed to match gauge. You can use DPNs or circular needles – if using circular needles, it’d be easiest to use a long (100cm/40in) needle for the baby/toddler/child sizes and work in magic loop, but the adult sizes could be worked on a 40cm (16in) needle.

Gauge: 24sts and 32 rows to 10cm (4in), measured over coloured panel, and 21sts and 27 rows to 10cm (4in) measured over stocking stitch (note: the pattern adjusts the stitch count between the panel and stocking stitch to allow for this difference).

Picking a size:
The hat is designed to be worn with 5-10cm (2-4in) of negative ease. Pick the size based on actual head measurements.

Size 0-6m
Head circumference: 38-41.5cm (15-16in)
Super slouchy: 80m / 88yds
Slightly slouchy: 55m / 60yds
Contrast: 30m / 33yds total

Size 6-12m
Head circumference 42-45cm (17-18in)
Super slouchy: 90m / 99yds
Slightly slouchy: 70m / 86yds
Contrast: 32m / 36yds total

Size Toddler (1-3y)
Head circumference 45-49cm (18-19.5in)
Super slouchy: 130m / 143yds
Slightly slouchy: 90m / 100yds
Contrast: 35m / 39yds total

Size Child (4-10y)
Head circumference 50-54cm (19.5-21.5in)
Super slouchy: 150m / 164yds
Slightly slouchy: 110m / 120yds
Contrast: 40m / 44yds total

Size teen/small adult
Head circumference 55-58cm (22-23.5in)
Super slouchy: 190m / 208yds
Slightly slouchy: 145m / 160yds
Contrast: 45m / 50yds total

Size large adult
Head circumference 58-62cm (23.5-25in)
Super slouchy: 210m / 230yds
Slightly slouchy: 170m / 186yds
Contrast: 50m / 54yds total