ABOUT THE PATTERN
The Flower Power Beanie is worked from bottom to top with one strand of DK/8ply yarn. It is knitted in the round on 4mm circular needles. You will start your work with a long tail cast on. Then you will knit stitches in 1x1 rib, followed by stockinette stitch. The flower detail is knitted flat on 4mm circular needles with the Intarsia method. Finishing by decreasing stitches at the crown of the beanie.

SIZES
S (M) L
Please measure your head before starting. If you prefer a looser fit, go up a size. Place a measuring tape just above your ear and across your forehead, wrapping round to the back of your head (don’t pull too tightly).

Size: S (M) L
Cm: 50 - 56 (56 - 63) 63+

SAMPLE/GAUGE
Gauge before blocking on 4mm needles.
Stockinette stitch = 20 st x 28 rows = 10 x 10 cm
1x1 Rib = 30 st x 23 rows = 10 x 10 cm

YARN AND MATERIALS
• Col 1: 50g (55g) 60g of 8ply yarn
• Col 2: 30g (35g) 40g of 8ply yarn
• Col 3: 20g (25g) 30g of 8ply yarn
• Col 4: 10g (15g) 15g of 8ply yarn
Yarn used in photos: Luxury 8ply Wool from Bendigo Woollen Mills (50g = 100m).
• Circular needles: 4mm
• Tapestry needle
• Scissors
Please note yarn weights for col 2 - 4 account for extra/left over yarn. It helps to have more yarn when knitting intarsia so you can seperate the yarn into ends/bobbins.

CONTACT
Please email me directly if you have any questions: chunkyboyknits@gmail.com

PLEASE NOTE:
There are strictly NO returns or refunds due to this being a digital download. In purchasing this pattern you agree to use it for personal/non-commercial use only. This pattern is protected by copyright laws and can not be re-sold, shared, recorded, altered, redistributed or copied in any way. In buying this pattern you accept these terms.