Schene

Knitting
December 2022
Fingering (14 wpi) ?
30 stitches and 34 rows = 4 inches
in colourwork in the round
US 2½ - 3.0 mm
2078 - 3718 yards (1900 - 3400 m)
English
This pattern is available for £6.50 GBP buy it now

Schene
A comfortable allover that’s also a winter statement piece. Schene is an old Scots word for “fine.”

Yarn
Kate Davies Designs Milarrochy Tweed (70% Wool; 30% Mohair; 100m / 109yds per 25g ball) in the following shades:

Colourways:
Kate
A Horseback Brown: 5 (5, 6, 6, 7, 8, 9, 9) x 25g balls
B Backen: 5 (5, 6, 6, 7, 8, 9, 9) x 25g balls
C Birkin: 2 (2, 3, 3, 3, 3, 3, 4, 4) x 25g balls
D Smirr: 2 (3, 3, 3, 4, 4, 4, 4) x 25g balls
E Stockiemuir: 2 (2, 2, 2, 2, 3, 3, 3) x 25g balls
F Tarbet: 2 (2, 2, 2, 2, 3, 3, 3) x 25g balls
G Hirst: 1 (1, 1, 1, 1, 1, 1, 1) x 25g ball

Iona
A Tarbet: 5 (5, 6, 6, 7, 8, 9, 9) x 25g balls
B Lochan: 5 (5, 6, 6, 7, 8, 9, 9) x 25g balls
C Smirr: 2 (2, 3, 3, 3, 3, 3, 4, 4) x 25g balls
D Stockiemuir: 2 (3, 3, 3, 4, 4, 4, 4) x 25g balls
E Asphodel: 2 (2, 2, 2, 2, 3, 3, 3) x 25g balls
F Cranachan: 2 (2, 2, 2, 2, 3, 3, 3) x 25g balls
G Cowslip: 1 (1, 1, 1, 1, 1, 1, 1) x 25 g ball

Needles and Notions
Gauge-size and below gauge-size circular needles of appropriate lengths for working body and neck
Gauge-size and below gauge-size needle(s) of your preferred type for working small circumferences (sleeves)
2 spare gauge-size needles for three-needle bind off 6 stitch markers
Waste yarn for holding stitches
Tapestry needle

Gauge
30 sts and 34 rounds to 10cm / 4in over colourwork in
the round on gauge-size needle(s). If your gauge tends to tighten when working small circumferences, you may need to go up a needle size for sleeves. Use 3mm needle as a starting point for swatching.

Sizes
Finished bust circumference: 89.5 (98, 105.5, 113.5, 122, 130, 138.5, 146) cm / 35 1/2 (38 1/2, 41 1/2, 44 3/4, 48, 51 1/4, 54 1/2, 57 1/2 ) in
Shown in the first and fourth sizes on Kate and Iona.

Pattern notes
A neat, slightly cropped pullover with dropped sleeves and allover colourwork. Following a chart, the pullover is worked in the round to the underarms. Two steek bridges are added to enable the work to continue in the round, and a third steek is then added at the front neck, which is shaped with decreases. Once the body is complete, the shoulders are joined with a three-needle bind off and the three steeks are reinforced before being cut open. Two sleeves are picked up around the armscyes, and worked top down. When the neck edging is added, the pullover is complete. Note that steek stitches are not included in running stitch counts.