Seewolf by Anke Telschow

Seewolf

Knitting
November 2026
Samelin Dyeworks Merino Yak Linen
Fingering (14 wpi) ?
25 stitches and 40 rows = 4 inches
in Sailor's rib
US 2 - 2.75 mm
US 1 - 2.25 mm
1531 - 1969 yards (1400 - 1800 m)
S, M, L, XL, XXL (with hip circumference 102 to 131 cm)
English German
This pattern is available for €7.00 EUR buy it now

Introduction offer until Sunday 15th of November 2026:
20% off (applies for ALL my patterns). No coupon code needed.

“Seewolf” is a sweater with an unusual construction. It is worked top-down, with a Raglan shape, like so many others. But it starts with a rolling neck edge which is deeper at the front. Using short rows, the front neck stitches are gradually added in pattern (and the extra stitches for the additional neck depth are decreased).

The stitch pattern on the sleeves is different from the body: similar look and feel, but with eyelets, so that the skin only peeks through where it should.

When you reach the underarm, the sleeve stitches are put on hold, and the center panels of back and front are continued in rows down to the hem, separately, in the “closed” stitch pattern. Afterwards, stitches are picked up from the edges, joined with the sleeve stitches and continued vertically to the outside, using the open version of the stitch pattern, plus short rows for a bat-like shape. After the body has been joined at the sidelines, the sleeves are continued in pattern to desired length, ending with a rolling edge.

At the end of the document, you will find some hints how to work the sweater with a straight shape (without the side panels), called the “Seehund” version.

This pattern is not suited for beginners - it is demanding because you need to

  • work short rows for the neck and at the sidelines
  • work the 2 (easy) stitch patterns also from the other side during the short rows
  • integrate newly increased stitches into the stitch pattern

(If this proves to complicated: I have added an afterthought annex with instructions how to approach the upper body without short rows and the stitch patterns worked from the other side.)

Anyway, I promise you a challenging and entertaining knit experience!
(After the upper body is finished, it becomes much easier and could be considered for TV knitting.)

Needles:** Main needle size is 2,75mm (it would normally be 3,0mm or even 3,25mm for this yarn, but the ribbed stitch patterns require a smaller needle); 2,25mm for edges.
Gauge: 25 sts x 40 rows (blocked!) in “Sailor’s Rib” and “Open Twisted Rib” stitch patterns.

Yarn: Approx. 1400/ 1500/ 1600/ 1700/ 1800 m of a Fingering weight yarn needed.
For my bat-wing sample, I have used Samelin Dyeworks Merino Yak Linen (400m/ 100g). For the straight slipover sample, Skudderia Baby Merino (50% Baby Alpaca, 50% Merino, 400m/ 100g) was used.