Wryit

Knitting
September 2020
DK (11 wpi) ?
22 stitches and 30 rows = 4 inches
in stockinette / moss stitch in the round
US 6 - 4.0 mm
962 - 1804 yards (880 - 1650 m)
81.5 (89, 92, 98, 103.5, 112.5) [118, 130, 135.5, 146.5, 152.5] cm / 32 (35, 36¼, 38½, 40¾, 44¼) [46½, 51¼, 53¼, 57¾, 60] in
English
This pattern is available for £6.50 GBP buy it now

A kit to knit this sweater is available from the KDD shop

Wryit

Twisting, turning cables combine with moss stitch to create a pleasingly textured pullover. Wryit is an old Scots word for twisted.

Yarn
Kate Davies Designs Schiehallion (100% Wool: 70% Corriedale, 30% Cheviot, 110m/120yds per 50g skein)

Crowdie: 8 (8, 9, 9, 10, 11) 11, 12, 13, 14, 15 x 50g skeins

Check sizing table for garment dimensions. If you wish to add length to body or sleeves, you may need an extra skein of yarn.

Needles and Notions
Gauge-size and below gauge-size circular needles of appropriate lengths for working body
Gauge-size and below gauge-size needle(s) of your preferred type for working small circumferences
Above gauge-size needle for joining neckband
Stitch markers of two types, x and y
Cable needle (if preferred)
Waste yarn for holding stitches
Tapestry needle

Gauge
22 sts and 30 rounds to 10cm / 4in over stockinette and moss stitch in the round and back and forth using gauge-size needle. Use 4mm needle as a starting point for swatching.
Stitch counts have been calculated taking into account the proportionate drawing-in effect of the cable panels.

Sizes
Finished bust circumference: 81.5 (89, 92, 98, 103.5, 112.5) 118, 130, 135.5, 146.5, 152.5 cm / 32 (35, 36¼, 38½, 40¾, 44¼) 46½, 51¼, 53¼, 57¾, 60 in

Select the size above your actual bust measurement with the amount of ease required. Shown in the second size.

Pattern notes
This pullover is knitted from the top down, with cable panels set against a ground of stockinette on the front and back and the sleeves worked in moss stitch throughout. A few stitches are cast on, and the front neck is shaped while working back and forth. After stitches are added for the front neck, the pullover is joined to be worked in the round, and the front panels are established while shaping the sleeves and upper body with raglan increases. Sleeve caps are divided and set aside, then the body is worked in pattern to the desired length. Sleeves are picked up and worked top-down, and the ribbed neckline is finally picked up, folded over, and joined to the inside of the pullover with a three needle bind off.