TAAT on 100cm circular. Other Ravelers complaining this sock is too wide overall and in the heel. CO and increased to 64. Left out ribs on sides of cable panel (=4 stitches from instep) and subtracted 4 from sole to give 32 on instep and 32 on sole for foot, worked toe up Dutch heel to make heel narrower and instep higher, then reduced to 72 (as in pattern). Foot on 2mm, leg on 2.25mm. Used instructions from here for Dutch heel but made it on stitch counts in my notes

Started gusset increases on round 30 of chart, worked till 64 stitches on heel needle.

The pattern recommends a merino cashmere mix yarn. Mine contained a bit of silk and is quite slippery, in spite of the bit of mohair. This meant I had to use a cable needle - and there are many, many cables in this pattern. I lost count of the number of times I made a mistake and had to drop a cable down and work it up again. The cable panel is gorgeous, and pretty complex. So I would recommend you use a slightly “grippy” yarn. I also wouldn’t recommend this sock for a first attempt at TAAT. The tinking involved if your attention wanders slightly in that cable panel……

I made my side ribs 2/2 after the heel, simply because I’m not keen on 1/1 ribbing. But you really have to use 1/1 for the top of the cuff. I tried 2/2 and ripped it back. It looked awful coming out of the cable panels.