11-28-2025

There are definitely errors with the pattern. When doing the index finger, it says to knit 5, cast on 3, then knit 5 again. But it claims this is a count of 18. Then at the end of knitting the finger, it tells us to k2tog around to end up with 9. So the original beginning count for knitting the finger must be wrong. The finger is too narrow to be able to slide my own finger into it so I’m going to have to rip it out and figure out how many stitches around I need to knit and cast on.

11-28-2025

changing index finger to 7 stitches each side plus 4 pickup

11-30-2025

Only doing 2 inches of cuff ribbing since I’m not sure whether I have enough yarn to do the second glove.

12-01-2025

The pattern has some inconsistencies, such as telling to pick up from stitch holder early in directions but hadn’t been told to put stitches on holder. Also a bit confusing where to start adding fingers after knitting the little finger. Usually glove patterns contine adding fingers next to each other, but this pattern jumps from little finger to index finger. Not sure if the labels for index and ring finger were reversed or if it really expected to switch to opposite side to keep adding.
Also, I needed to pick up more stitches between fingers to avoid gaps. I picked up 2 more stitches and then k2 or ssk on the next round.

I wouldn’t recommend this for someone that hasn’t knitted gloves before, but if you’ve done a few gloves before then you can figure out what is intended.

Despite the small pattern glitches, this is a really fun pattern and I will definitely make some more pairs from this after I finish my second glove.

12-04-2025

Figured out the index finger stitch count discrepancy. In the initial setup rounds after grafting the thumb seam, it has you pick up 4 stitches. The directions don’t mention knitting these for the index finger, but these are included in the count. So the first round of ring finger (for size L) is actually knit 4, then knit 5, then LCO 3, then knit 5 = 17.