Description
Cozy, soft, and just the right amount of slouchy—this off-the-shoulder jumper is the perfect mix of effortless and comfy. Made from a dreamy blend of wool and mohair, it’s super warm without feeling heavy.

Materials
Knitted with one strand of Filcolana Peruvian Highland Wool (350-450g) and one strand of Filcolana Tilia Mohair & Silk blend (100-125g)
stitch markers
spare knitting needle
elastic (0.7 - 1cm wide)

Needles
5mm 80cm/100cm circular needles, 5mm 40cm circular needles

Swatch
19 stitches & 24 rows for a 10x10cm swatch

Sizing
This is a fitted jumper, meaning sizing depends on your bust circumference - refer to this sheet

Difficulty
3/5. The jumper takes approximately 2-3 weeks.

Start by making a swatch using the swatch measurements above. Since this is a fitted Jumper, it’s important you make sure you follow the swatch measurement, and note down your bust + arms circumference in cm.

This jumper is worked from top to bottom, starting with the elastic band to keep it secure and in place. First, we cast on stitches and knit until we reach twice the width of the elastic. Then, we fold it over and close it off before moving on to the main body.

Next, we shape the armholes by leaving out stitches, then continue knitting the body in a knit stitch. Once the length is right, we finish it off with a rib stitch and cast off using an Italian bind-off for a clean and stretchy edge.

After that, it’s time for the sleeves. We pick up stitches at the armholes and knit the sleeves, decreasing every few rows to create a nice tight fit. Like the body, the sleeves are mostly knit stitch with rib stitch at the end, finished off with an Italian bind-off.

The final step is the rollover detail. We go back to where we first cast on, pick up one stitch for every existing stitch, and work in a rib stitch to keep it stretchy. Once it’s the right length, we use an Italian bind-off to neatly close it off.