Style TYLERJACKET is a knitwear pattern instructions.

The pattern comes in a PDF file, and can be downloaded and printed from the computer.

Size chart

Size (cm) XS - S (M - L) XL - XXL (3XL - 4XL)

1.Overall width (body)

109 (115) 121 (127)

2.Length on yoke

23,5 (24,5) 26 (27)

3.Length on body to armpit

39 (41,5) 43,5 (44)

4.Lenght on sleeves to armpit

51,5 (53) 54,5 (53,5)

The measurements are based on the size of the jacket after washing.

Level : Average

Material

Organic Merino Aran. 100g hand dyed merino wool aran weight yarn from Thelma Steimann. Approximately 166m per 100g. Smooth, soft, non-scratchy yarn.

Col 1: 4/5/5/5/6

Col 2: 1/1/1/1/1

Col 3: 1/1/1/1/1

Col 4: 1/1/1/1/1

Circular needle 40 and 80 cm in 5 mm.

Circular needle 80 cm in 4 mm.

Circular needle 80 cm in 5,5 mm (optional, for knitting printwork to keep the gauge).

4 – 5 DPN in 4 mm.

Tapestry needle for stitching the threads.

2 x long safety pins or scrappy yarn.

10 x stitch markers (optional to use more when knitting the printwork).

Zipper, length 30 - 40 cm, depending on the size. Take note that it is best to measure zipper length after the jacket has been washed.

Tension gauge sample

Be sure to check your own tension before starting to knit.

Cast on 20 stitches and knit 23 rows on needles 5 mm for a 10 x 10 cm sample.

If tension measures too tight, change to a thicker needle.

If tension measures too wide, change to a thinner needle.

Good to know

The jacket is knitted from top to bottom from right and wrong side, starting from the yoke with an increase. After the yoke has been knitted, the jacket is divided up for the sleeves and the body. The jacket body is connected and knitted in round with the print work, with 2 or 3 strands of colours at the same time. It’s optional to change over to a slightly bigger

needle if needed in the print work. The jackets are washed and blocked before it’s opened up from the middle in the front. Use a sewing machine to secure the stitches before cutting the jacket open. The edge is knitted onto the jacket and then the zipper is attached, by either hand sewing it on, or using a sewing machine.

Yarn quantity required is based on an average , and is therefore an approximate number.

The sweater can be knitted in any yarn that consists of the same thickness as Organic merino aran.

When working with hand dyed yarn, it’s recommended to check through the yarns and see if there are some hanks that might look slightly different from one another. If you have a hank that is slightly different from the rest of the hanks in color 1, use it while knitting the print work to create additional effect in the printwork. This is just an option and a playful tip, to highlight the uniqueness of working with hand dyed yarns.