1:12th scale Mans Tudor hose and cap
Ability Level: Intermediate. This is NOT suitable for a first project in miniature knitting.
Hose - size 19 (1.00 mm/US size 5/0) knitting needles, 55 yards/50 metres 1-ply wool.
Cap - size 19 (1.00 mm/US size 5/0) knitting needles, 28 yards/25 metres 1-ply wool.
Note: the cap may be knit for a boy by using size 21 (0.80 mm) knitting needles in place of size 19 (1.00 mm/US size 5/0) knitting needles. If required the cap may be felted (as would have been the norm in Tudor times), however you must use a pure wool and remember the felting process will remove any mothproofing added by the manufacturer. The cap will shrink considerably on felting.
Approximate finished sizes:
Cap - 1¼-inches/ 3.5 cm diameter
Hose - ¾-inch/2 cm at thigh, 3-inches/7.5 cm from toe to thigh, heel to toe ¾-inch/2 cm
Gauge – Gauge is not important as dolls house dolls vary greatly in size.
BEFORE PURCHASING PATTERN PLEASE NOTE:
Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.
Full terms and conditions can be found here.
Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.