1:24th scale chair backs set
This is NOT suitable for a first project in miniature crochet, due to the very tiny hook and fine thread used.
Materials required for the whole set (2 chairs and settee):
size 0.40 mm crochet hook, 1 ball No. 80 crochet cotton or No. 70 Tatting thread
Approximate finished sizes:
Tablemat - ¾-inch/2 cm long by ½-inch/1.25 cm wide
Chair back - ¾-inch/2 cm wide by 1¼--inches/3 cm long
Chair arm cover - 1¼--inches/3 cm across chair arm, ¼-inch/1 cm square at end of chair arm by ¾-inch/2 cm deep
Gauge: is not important in this project, as miniature chairs and tables vary in size
Also shown in photograph is the knitted mantel cover, which is not included in this pattern, but is available to buy on a separate pattern.
BEFORE PURCHASING PATTERN PLEASE NOTE:
Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.
Full terms and conditions can be found here.
Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.