1:6th scale Hooded sweatshirt
Ability Level: Experienced
Designed to fit a 32.5 cm/13-inch tall doll such as Ken, GI Joe, Action Man or other similar teenage/fashion doll
Materials required: one pair of size 2.00 mm knitting needles; plus one spare size 2.00 mm knitting needle; 90 metres/97 yards/15 grams No 10 crochet cotton; 2 stitch holders or safety pins.
Finished size of sweater:
Neck to hem - 12 cm/4½-inches; Sleeve seam – 8.75 cm/3½-inches; Sleeve length - 10 cm/4-inches; Width across chest - 7.5 cm/3-inches.
Gauge - worked over rib stitches at base: 6 rows = 1 cm and 5 stitches = 1 cm
NOTE: This has been designed to give the illusion of a zipped garment, as although zips are available this small, they are very bulky when used on miniature garments. The ‘zip’ is unzipped to allow room to pull the sweatshirt over a dolls head. The inside of the pocket has been left as a tube, as this hangs better, but may be tacked along the ‘zip’ line. The sweatshirt is also made slightly ‘baggy’ to allow other clothes to be worn underneath if required.
BEFORE PURCHASING PATTERNS PLEASE NOTE:
Cancellation of digital goods Under the UK provisions of Consumer Contracts (Information, Cancellation and Additional Charges) Regulations 2013 the following conditions will apply: By clicking the download button(s) on the Ravelry download page you expressly request that the digital content is immediately available for download (this may be within the 14 days statutory cancellation period) and you agree to waive your right to cancel and refund once the download(s) has started.
Full terms and conditions can be found here.
Copyright Notice All rights reserved. All patterns are for private use only and may not be reproduced in any form, or reproduced for commercial gain including selling any item knitted up from these patterns without written permission from Buttercup Miniatures. Reproducing or transmitting these patterns by any means for any purpose other than for personal use constitutes a violation of UK copyright law.