Gauge obtained on 3.75mm needles
Lace bodice worked on 3.5mm

Mods / advice:

Working a slip stitch edge on the top edge of the yoke pieces works well to stop it stretching out.
Don’t be tempted to work a slip stitch edge on the bottom of the yoke pieces, as although it will make it easier to pick up stitches it will be too tight.

Cuff edging worked as follows;
Switch to smaller needles:
R1: * k2tog, yo, * repeat to end.
R2: k
R3: p
Repeat rounds 2&3 for as many garter ridges are desired. I worked 3.
Jenny’s surprisingly stretchy bind off.

Bottom edging the same (just converted to work flat), though I worked an extra garter ridge here.

Not sure how much yarn I used, I need to weigh it.