Holly Beret by Amanda Clark

Holly Beret

Knitting
November 2011
Fingering (14 wpi) ?
28 stitches and 34 rows = 4 inches
in stocking stitch
US 3 - 3.25 mm
156 - 174 yards (143 - 159 m)
To fit an average sized head (21 inches), approximately 10 inches/25.5 cm wide in diameter when laid flat.
English
This pattern is available for £1.00 GBP buy it now

Please check this Shuttermonkey Designs Discussion Thread to find out the latest discounts and/or promotions currently running on my designs.

This is a slouchy beret, knitted in the round and worked in one piece from the bottom up. After casting on using a long tail tubular cast on method for 1x1 rib, the brim is worked before commencing onto a beaded section to knit the holly motif. This is then followed by the crown shaping of the beret and an I-cord finish.

Instructions for this beret are provided in both written and charted format.

If you have any questions, problems or just want to join in with others who are knitting this shawl, pop over to my Shuttermonkey Designs Group here on Ravelry.

You can also find me on Facebook too.